How-to guide
Change the print roll
Read how many prints are left, change the roll and its ribbon between sessions, and confirm the booth has seen the new roll. What the booth shows before, during, and after, and where the physical steps come from.
The printer takes a roll of 4x6 paper and a matching ribbon, and the two run out together. The booth counts the prints left on the roll and shows the number in the admin area, reports it to the cloud, and stops selling when the roll is empty. This page is about that count and about what the booth shows before and after a change. The physical change itself belongs to the printer: follow the instructions that came with it and with the media.
Before you start
- One roll is 700 prints of 4x6, or 1,400 strips, because a strip is half a sheet the printer cuts in two. Each roll ships with its own ribbon, and the two are changed together; see What's in the box for the media and why the printer takes only its own.
- Have the new roll and ribbon at the booth before you open the printer. An open printer is a booth that cannot print.
- Change the roll between sessions. Once the printer reports the paper gone, the booth shows Out of Order with code P-003, "Out of Paper", and takes no sessions until the printer reports paper again; see The booth shows Out of Order.
Read the count
- Open the admin area. The top bar shows "Prints:" and a number. The number is what the printer has reported; it reads "--" until the printer has said anything.
- For the detail, open Diagnostics. The Printer card shows the paper level as OK, Low, Out, or Unknown, and Test Connection asks the printer again right now instead of showing the cached status.
- The booth sends the count to the cloud with every heartbeat, and by default the app warns you when the roll falls to about a fifth and raises a critical alert at a tenth. A low roll never stops the booth; only an empty one does.
If the count is less than the day needs, change the roll now rather than mid-session. The morning routine on Open the booth for the day has this as its third check.
Change the roll and the ribbon
- Wait for the booth to be between sessions, and stay signed in to the admin area while you work. The booth checks its hardware only while it is on the welcome screen or already showing Out of Order, so from the admin area an open printer raises no Out of Order screen; left on the welcome screen, it can show Out of Order with code P-005, "Cover Open", until the door is closed again.
- Open the printer and change the roll and the ribbon together, following the printer's instructions. The booth plays no part in this step.
- Close the printer. If the booth was showing Out of Order, it checks the hardware again on its own countdown, or tap Retry Now to check straight away.
Verify it worked
- Print a test. On Diagnostics, Test 4x6 or Test Strips prints a calibration page through the same path a customer's print takes, so a good test print means a good session print. Test Print on the Settings tab prints a test page too.
- The Printer pill in the admin header is green and "Prints:" shows a full roll's count once the printer has reported it. The new count reaches the cloud on the next heartbeat, and the app's supplies alert clears with it.
- If the test print is streaky, blank, or the wrong color, the roll and ribbon are the first suspects; see Printer issues.
Last verified against the software on 2026-10-26.