How-to guide

Open the booth for the day

A five-minute check in the admin area before the first customer: the three hardware pills, the prints left on the roll, the mode, the credit balance, and one free test strip.

The booth needs no daily ritual to run. Switched on, it reaches the welcome screen by itself and waits. What this check catches is what you would otherwise learn from the first customer: a printer that went offline overnight, a roll with ten prints left, a mode still on Free Play after an event, or credits left over from a comp.

Before you start

You need the kiosk's admin login. To open the admin area, tap the top-right corner of the welcome screen five times, each tap within three seconds of the last, then sign in.

Check the booth

  1. Open the admin area. The top bar shows three pills, Camera, Printer, and PCB (the payment board that reads bills and cards). A pill is green while that part is connected and red when it is not. The same bar shows the mode after "Mode:" and the prints left on the roll after "Prints:".
  2. If a pill is red, fix that before opening. See Printer issues, Camera not working, or Payment not registering.
  3. Read "Prints:". It is the number of prints left on the roll as the printer reports it, or "--" when the printer has not said. If it is less than the day needs, change the roll now rather than mid-session: see Change the print roll.
  4. Read "Mode:". It says "Coin Operated" or "Free Mode". To change it, open Products: see Set prices and switch between Coin Operated and Free Play.
  5. Open Credits and check the balance. In Coin Operated mode a balance left over from yesterday lets the next customer start without paying. To clear it, enter the amount and tap Deduct, or tap Reset Balance to $0 under Danger Zone and confirm.
  6. Run one session yourself. Switch to Free Play Mode in Products if the booth is in Coin Operated mode, tap Exit Admin, and go through a session as a customer would: the steps are in Print your first strip. Check the strip for streaks, color, and focus.
  7. Open the admin area again, switch the mode back if you changed it, and tap Exit Admin.
There is nothing to check on the Cloud Sync tab

The badge on the Cloud Sync tab shows whether the booth is linked to its account, not whether it is online right now. To see that the booth is reporting, open the BoothIQ app: the booth's card reads Online once a heartbeat has arrived in the last five minutes.

At the end of the day

Verify it worked

  • All three pills are green, "Prints:" shows a number, and "Mode:" reads what you intend.
  • The welcome screen is showing, with no "Unlicensed" badge, and the test strip looks right.

Last verified against the software on 2026-10-21.